Edited by EishiFUN
Hello Community,
Is there a way to have a report that strictly highlights the after hours use of fleet vehicles? It would be helpful to easily pull out the evenings and weekends/holidays segments rather than having to go look through a timeline for every asset.
Thanks,
S.
You need to be logged in to reply to this post and participate in the Geotab Community discussions.
Hey @SNayak-1704 ,
Thank you for asking your question in our community. I feel like I have seen good reports for this before. You could use the rule and just run an exceptions report for that rule and you should find what you are looking for but there may be a better way. What would you suggest as the best way to do this @ssartor-1546 or @JoyB-1751 @postmelon-1566 .
I am sure one of them will have a good answer but if they are busy or unable to help I will see if I can find any other suggestions.
Have a good one!
Eishi FUN
Hey @SNayak-1704 ,
Thank you for asking your question in our community. I feel like I have seen good reports for this before. You could use the rule and just run an exceptions report for that rule and you should find what you are looking for but there may be a better way. What would you suggest as the best way to do this @ssartor-1546 or @JoyB-1751 @postmelon-1566 .
I am sure one of them will have a good answer but if they are busy or unable to help I will see if I can find any other suggestions.
Have a good one!
Eishi FUN
Hey, @SNayak-1704!
I would recommend what @EishiFUN said about creating a rule (or several, depending on what you're looking to pinpoint) and running an exceptions report on that to see what's up after hours.
Hope this helps. :)
Best,
Joy B