I applied a bulk accelerometer reset parameter via SDK and I want to know if the reset was applied to the device.
Skip to main content
Join the conversation
You need to be logged in to reply to this post and participate in the Geotab Community discussions.
Top Answers
@****-6175 Check the engine measurements for the "Accelerometer calibrated (1. Calibrated)" logs. If it's going to 0 then it means it's not calibrated and if it's 1 then it calibrated. Ideally you'd want to see it go to 0 after the power up and going to 1 after a few trips.
1 Reply
@****-6175 Check the engine measurements for the "Accelerometer calibrated (1. Calibrated)" logs. If it's going to 0 then it means it's not calibrated and if it's 1 then it calibrated. Ideally you'd want to see it go to 0 after the power up and going to 1 after a few trips.
Still have questions?