Skip to main content

Can I search for a partial VIN in My Admin

CarmineTWEX-1098
Original Poster

We are looking to identify certain vehicles within our databases.

Join the conversation

You need to be logged in to reply to this post and participate in the Geotab Community discussions.

Top Answers

That's a good question!

NO- although you can search by VIN and can enter only a portion of a VIN for a query (via MyAdmin > Device Management > More Filters), the system will NOT return any results unless the FULL VIN is queried. . .

I just did a test run with a known VIN tied to an asset under my scope to see how it would behave. No results were returned for any queries that were short of being the FULL VIN (I tried numerous variations).

On a side note, querying with leading and/or trailing spaces did not impact the results (so long as the entire VIN was entered). Hope this helps!

Thanks!

1 Reply

That's a good question!

NO- although you can search by VIN and can enter only a portion of a VIN for a query (via MyAdmin > Device Management > More Filters), the system will NOT return any results unless the FULL VIN is queried. . .

I just did a test run with a known VIN tied to an asset under my scope to see how it would behave. No results were returned for any queries that were short of being the FULL VIN (I tried numerous variations).

On a side note, querying with leading and/or trailing spaces did not impact the results (so long as the entire VIN was entered). Hope this helps!

Thanks!

Still have questions?