Public installation

For third-party installers without a Geotab account who verify a new device installation with or without an installation code.

The public installation flow is available at install.geotab.com. Select I have an install code to use a code from the fleet manager, or select I do not have a code to follow the legacy process. For installations without a code, the device must already be added to the correct MyGeotab database.

Note: If you have a Geotab account, use New device installation instead for the full installer workflow, including remove, swap, and service.

To get an accurate status reading, the engine needs to be running and the device's red and green LEDs need to be lit.

New device installation

For third-party installers without a Geotab account who verify a new device installation with or without an installation code.

As an installer, you run this check during the install. The check confirms the device is connected to the network and captures asset details.

  1. Go to install.geotab.com.
  2. Select I have an install code if the fleet manager provided a code, or select I do not have a code to use the existing installation process.

    For an installation without a code, the device must already have been added to the correct MyGeotab database before installation.

  3. If you selected I have an install code, enter the code provided by the fleet manager and select Begin installation.
  4. If you entered an installation code, confirm that the Customer name on the screen matches the Customer you are installing for. If it does not, select No, this is incorrect.
  5. Enter the serial number of the installed device in any of the following ways:
    • Scan the device serial number (QR or bar code) using your mobile device.
    • Tap Enter serial number manually, enter the serial number, then tap Confirm.

    If you are also removing a non-Geotab device, tap Did you remove an old device? to enter the removed device serial number.

  6. Review the device status.

    The app takes a moment to check the device status and displays the result as a Pass or Fail.

    DevicePassFail
    GO device or third-party deviceCommunicated with the network within the last 24 hours.Has not communicated with the network within the last 24 hours.
    GO AnywhereCommunicated with the network within the last 75 hours.Has not communicated with the network within the last 75 hours.
  7. Under Check device status, review the device status.
  8. Tap Continue.
Asset details
  1. Under Input asset information, select the relevant Asset type from the dropdown.
  2. Enter details about the vehicle or asset where the telematics device was installed.
    Note: Fields displayed may vary based on the asset and device type.
  3. Tap Continue.
Installation photos
  1. Upload photos of the installation.

    You can take a photo with your mobile device or attach an image from your photo library. The number of photos required depends on the device being installed.

    Important: Ensure that photos do not capture personally identifiable or confidential details.
  2. Tap Continue.
Review and finish
  1. Review details by tapping any section. If needed, update any captured details.
  2. Tap Finish.
The installation is verified.