Support Document
0 mins to read
Data Set for Geotab Integrated Solution for International Trucks
Support Document
0 mins to read
Learn which data attributes and data frequencies are available with Navistar Premium, including ignition status, GPS location, odometer, tire pressure, engine information, and more.
Geotab Integrated Solution for International Trucks
Name in MyGeotab UI | Data Frequency 2 (Navistar Premium) |
GPS Coordinates | Every 5 seconds |
Ignition | Event based (ignition change) |
Engine road speed | Every 5 seconds |
Odometer | Every 5 seconds |
Acceleration forward or braking 1 | Reported only when value is above threshold |
Acceleration side to side 1 | Reported only when value is above threshold |
Accelerator pedal position | Every 5 minutes |
Telematics device voltage | On ICE vehicles: Available only after the battery drops below 11 Volt. When data is available, it’s sent every 5 minutes On EV: Event based |
Engine operational time | Every 5 minutes as well as event (ignition change) |
Total engine idle time | Every 5 minutes |
Engine speed | Every 5 minutes |
Total fuel used (since telematics device install) | Every 5 minutes |
Total fuel used while idling (since telematics device install) | Every 5 minutes |
Power takeoff total fuel used (since telematics device install) | Every 5 minutes |
Gear position | Every 5 minutes as well as event (gear change) |
Parking brake (1 = on) | Event based (only at ignition ON) |
Fuel level (percentage) | Every 5 minutes |
Coolant level | Event based (only at ignition ON) |
Engine load | Every 5 minutes |
Engine oil temperature | Every 5 minutes |
Engine coolant temperature | Every 5 minutes |
Engine intake manifold 1 temperature | Every 5 minutes |
Tire pressure: axle # tire # | Every 5 minutes |
Tire temperature: axle # tire # | Every 5 minutes |
Flashing amber light (1 = on) | Event based |
Dash warning light amber lamp (1 = on) | Event based (only at ignition ON) |
Dash warning light red lamp (1 = on) | Event based (only at ignition ON) |
Idle shutdown timer enabled (1 = enabled) | Event based (only at ignition ON) |
Corresponding Fault Code / DTC | Event based |
Generic state of charge [%] | Every 15 seconds |
Electric vehicle charging state (0 = not charging / 1 = AC charging / 2 = DC charging) | Event based |
Electric vehicle distance remaining [Km] | Every 60 seconds |
Hybrid/EV battery temperature [degC] | Every 15 seconds |
Electric vehicle battery total energy out while driving (since telematics device install) [kWh] | Event based |
Electric vehicle battery total energy in while driving (since telematics device install) | Event based |
Electric vehicle battery total energy out during DC charging (since telematics device install) [kWh] | Event based |
Electric vehicle battery total energy in during DC charging (since telematics device install) [kWh] | Event based |
Outside air temperature | Every 60 seconds |
Telematics device voltage | Event based |
1. Reported only when data thresholds are breached:
- Forward acceleration (Hard Acceleration): Greater than 0.6G
- Backward acceleration (Harsh Braking): Greater than 0.6G (-ve direction)
- Side to side acceleration (Harsh Cornering): Greater than 0.6G
2. The stated frequency shall be interpreted as the minimal, as a Data Attribute comes in via its own stream, as well as certain events. E.g. GPS Location has its own stream, where data comes in every 5 seconds. When harsh braking occurs, additional GPS Location data comes in. The result is GPS Location appearing more frequently than every 5 seconds on MyGeotab
