GO10 Plus Quick Start Guide
Installation and setup instructions for the GO10 Plus device.
Installation prerequisites
Complete these steps before installing a GO10 Plus device.
In the box
Verify that the GO10 Plus package includes all listed components before installation.
Check the package contents before beginning installation.
Item | Quantity | Picture |
|---|---|---|
GO10 Plus device | 1 | |
Cable ties | 2 | |
Product identification labels | 2 | |
CARB E.O. identification label (U.S. SKUs only) | 1 |
Installing the GO10 Plus
Install and validate the GO10 Plus device using the vehicle's OBD-II port and harness.
1. Locate OBD-II port and free connector
Locate the vehicle's engine diagnostic (OBD-II) port, typically found in the driver-side footwell. For certain vehicles, panels may need to be removed to access the OBD-II port.
Pull the OBD-II port out and detach its connector from its mounting location on the dash. Depending on the vehicle, it might be fastened to the dash via screws or a clip/snap mechanism.
2. Assemble harness
Choose the adapter from the kit that most closely matches the original port.
Once you have the adapter, slide it onto the short harness until you hear it click securely. If it doesn't click, flip the adapter and try again.
Connect the two harness pieces together, as shown below.
3. Connect harness to OBD-II port
Connect the harness to the vehicle's engine diagnostic (OBD-II) port. Secure the connection with a cable tie.
4. Mount harness to OBD-II port
Mount the adapter to the OBD-II port's original location. Ensure the cable does not interfere with any moving parts.
5. Connect harness to GO device
Plug the harness into the GO10 Plus device. Make sure the harness clicks in place to ensure the connection is secure.
6. Turn on vehicle ignition
Turn on the vehicle ignition to initiate GO device startup and initial configuration.
The LED light will flash slowly during startup, which typically takes 60-80 seconds.
Warning:
Do not unplug or touch the device during this time.
30 seconds after startup, you should see a solid green light. If you do not see a solid green light, look for the LED pattern in the table below to help you troubleshoot the issue.
| LED state | What the device is doing and what to do |
|---|---|
Slowly flashing white | Initializing / waking up. Do not power off the device; wait for it to finish. |
Quickly flashing white | Firmware updating. Do not power off the device; wait for the update to finish. |
Quickly flashing orange | Weak or no cell signal. Move the vehicle to an area with better cellular coverage. |
Flashing orange twice | Weak or no GPS signal. Ensure the vehicle is in clear view of the sky. |
Solid green | Device on and working. The device is operating normally; no action is needed. |
Quickly flashing green | No ignition detected. Ensure the vehicle ignition is on. |
Flashing green every 3 seconds | Light sleep. The device is sleeping normally; no action is needed. |
7. Secure GO device
Secure the GO10 Plus device to the vehicle using at least 2 cable ties.
8. Validate GO device
Validate the installation using the Geotab installation tool. Navigate to install.geotab.com.
Regulatory statements
Review the California regulatory statement for GO10 Plus devices.
California
Only CARB-certified devices are allowed to submit on-board diagnostics (OBD) data to CARB. The device has been certified for use in Clean Truck Check from the date indicated in the Executive Order until the end of the calendar year, for a maximum period of one year. The vendor must submit the device to CARB to be recertified at the end of the certification period to continue participating in the Clean Truck Check. If the device no longer meets certification requirements, it can no longer be used to perform OBD Inspections, and a different certified device must be purchased.