Auxiliary input data labeling

Set up and check input labels on GO10 or GO10 Plus in MyInstall.

1. Open MyInstall through MyAdmin or the MyInstall services . Select New Installation.
2. Scan the device barcode or manually enter its serial number, starting with X, to locate GO10 or GO10 Plus.
3. On the Check device status screen, select Set up in the Auxiliaries / GPIO section of the device card.

   The data-labeling configuration page lists the available digital inputs.

   
   
   
4. Choose the appropriate use case from the dropdown for each digital input to label.

   Leave an input unassigned if it is not connected to anything in the vehicle.

   Note:

   Assign one use case to each input. Driver Seatbelt, PTO, and Cargo Door can each be assigned to one input only. Digital (generic) can be selected for multiple inputs.

   If returning to this screen during calibration, the use case selections are preserved.

   
   
   

   Select the use case for each connected input.

   
   
   

   Check the selected assignments before continuing.

   
   
   
5. Calibrate the configured inputs.
   Important:

   Before starting calibration, leave all seat belts in the vehicle unbuckled. Do not buckle any seat belt until the app instructs it.

   Calibration detects the difference between the buckled and unbuckled states. Starting with a seat belt buckled can prevent the device from correctly learning the signal.

   Select Continue on the use case selection screen. A loading screen appears for approximately 10 seconds while the device enters self-learning mode. Wait for this to finish before performing the physical calibration steps.

   MyInstall guides each configured Driver Seatbelt, PTO, and Cargo Door input through calibration, one at a time. The screen identifies the input number being calibrated. For each input:

   Note:

   The confirmation beeps come directly from the device. Stay close to it during calibration and use a reasonably quiet environment so the beeps can be heard.

   1. When prompted, set the input to the first state: buckle the seat belt, activate the PTO equipment, or open the cargo door.

      Wait for a beep from the device confirming that the signal was detected.

      
      
      
   2. When prompted, set the input to the opposite state: unbuckle the seat belt, deactivate the PTO equipment, or close the cargo door.

      Wait for a second beep confirming that calibration is complete.

      
      
      

   MyInstall confirms when the input configuration is complete.

   
   
   

   Important:

   Calibrate each input within 2 minutes. If calibration fails or times out, the entire configuration is canceled and no changes are saved. Restart from step 4 to assign the use cases. Select Back at any point during calibration; the use case selections are preserved.

6. Verify the configured inputs on the Check device status screen.

   After calibration, MyInstall returns to this screen and confirms that GPIO setup is complete. It displays the current labeled state of each input:

   Use case	States
   Driver Seatbelt	Buckled or Unbuckled
   PTO	Engaged or Disengaged
   Cargo Door	Open or Closed
   Generic Digital Input	0 (off) or 1 (on)

   Toggle each physical input and confirm that its state updates on screen. If it does not change immediately, select Refresh to fetch the latest reading from the device.