Safety and regulatory information
Safety warnings, limitations of use, and regulatory compliance information for GO® Anywhere Plus™.
Warranty
For full warranty terms, see the Geotab Limited Warranty Statement.
Warnings
Safety warnings for GO® Anywhere Plus™.
Professional installation required. Installation of this product requires that the installer have sufficient technical knowledge and expertise for mobile device installation and integration into modern vehicles, such as Certified Geotab Installer certification or equivalent.
Read important related safety information and Limitations of Use following these installation instructions. Read and follow all instructions and warnings to prevent serious injury and/or vehicle damage.
Some installations are not straightforward and must be completed by an Authorized Installer to ensure a secure installation. Some examples requiring professional installation from an Authorized Installer include if the device may not be fully secured and could vibrate loose, get knocked or if the installer questions their ability to complete a secure installation according to these instructions.
Do not attempt to install, reconfigure, or remove any product from a vehicle while the vehicle is in motion or otherwise in operation. All installation, configuration, or removal must be done only in stationary vehicles that are securely parked.
To prevent risk of fire or damage to the asset, the external power harness must be connected to an appropriately fused circuit. Failure to use a correctly fused power source can lead to an overcurrent condition, resulting in serious damage to the asset's electrical system and risk of fire.
The device may become hot to the touch during operation, particularly when externally powered in high-temperature environments. Exercise caution when handling the device after extended use.
To prevent equipment damage and ensure reliable operation, do not install the device where it may be exposed to corrosive chemicals or fuels.
Do not subject this product to powerwashing. Failure to do so may result in units malfunctioning or short-circuiting, which can lead to a fire hazard.
To prevent risk of fire, explosion, or chemical leakage, use only Geotab-approved replacement batteries. The use of unauthorized or incompatible batteries will void the product warranty.
Do not use a battery that is leaking, damaged, or deformed. Handle compromised batteries with appropriate personal protective equipment. Dispose of damaged batteries immediately according to local hazardous waste regulations.
Do not short-circuit the battery terminals. Allowing the terminals to come into contact with metallic objects can cause rapid overheating, leakage, or explosion.
The Geotab GO Anywhere is a monitoring device and is not a failsafe anti-theft or life-saving system. Device functionality depends on factors including battery charge, available GPS and cellular coverage, and proper installation. Do not rely on this device for emergency situations or as the sole means of asset security.
Important safety information and limitations of use
Important safety information and limitations of use for asset trackers.
For the latest version of the limitations of use, navigate to goo.gl/k6Fp0w.
This product does not contain any user-serviceable parts. Configuration, servicing, and repairs must only be made by an authorized reseller or installer. Unauthorized servicing of these products will void your product warranty.
Regulatory statements
Regulatory compliance statements for GO® Anywhere Plus™.
Warning: RF exposure compliance
This equipment complies with FCC and ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. In order to avoid the possibility of exceeding the FCC and ISED RSS-102 radio frequency exposure limits, this equipment should be installed and operated with minimum distance 20 cm (7.9 inches) between the antenna and your body during normal operation. Users must follow the specific operating instructions for satisfying RF exposure compliance.
Cet équipement est conforme aux limites d’exposition aux rayonnements FCC et ISED CNR-102 établies pour un environnement non contrôlé. Cet émetteur ne doit pas être installé ou utilisé en conjonction avec une autre antenne ou un autre émetteur. Afin d’éviter la possibilité de dépasser les limites d’exposition aux radio fréquences FCC et ISED, cet équipement doit être installé et utilisé avec une distance minimale de 20 cm (7.9 pouces) entre l’antenne et votre corps pendant le fonctionnement normal. Les utilisateurs doivent suivre les instructions spécifiques d’utilisation pour respecter la conformité à l’exposition aux RF.
Canada
CAN ICES-003 (B) / NMB-003 (B)
This device contains license-exempt transmitters/receivers that comply with Innovation, Science and Economic Development Canada’s license-exempt RSSs. Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This device complies with the Canadian ICES-003 Class B specifications. CAN ICES-003 (B).
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
- L’appareil ne doit pas produire de brouillage;
- L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
USA
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Geotab could void the user’s authority to operate the equipment.
Cancer and Reproductive Harm – www.P65Warnings.ca.gov
EU
Product wireless information:
- 703-748 MHz: Max 26.2 dBm EIRP (LTE B28)
- 824-849 MHz: Max 26.0 dBm EIRP (LTE B5)
- 832-862 MHz: Max 25.8 dBm EIRP (LTE B20)
- 880-915 MHz: Max 25.9 dBm EIRP (LTE B8)
- 1710-1785 MHz: Max 28.7 dBm EIRP (LTE B3)
- 1920-1980 MHz: Max 28.7 dBm EIRP (LTE B1)
- 2010-2025 MHz: Max 28.7 dBm EIRP (LTE B34)
- 2300-2400 MHz: Max 27.2 dBm EIRP (LTE B40)
- 2400-2483.5 MHz: Max 12.2 dBm EIRP (BLE)
- 2496-2690 MHz: Max 27.1 dBm EIRP (LTE B41)
- 2500-2570 MHz: Max 27.5 dBm EIRP (LTE B7)
- 2570-2620 MHz: Max 27.1 dBm EIRP (LTE B38)
Mexico
La operación de este equipo está sujeta a las siguientes dos condiciones: (1) es posible que este equipo o dispositivo no cause interferencia perjudicial y (2) este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada.
Brazil
Conforme resolução Anatel 680 - Art. 5º - Os equipamentos de radiação restrita devem conter no produto, em lugar facilmente visível, ou no manual de instruções fornecido pelo fabricante, em local de destaque, informação sobre as implicações de sua operação, nos seguintes termos: Este equipamento não tem direito à proteção contra interferência prejudicial e não pode causar interferência em sistemas devidamente autorizados. Para maiores informações, consulte o site da ANATEL (www.anatel.gov.br).
Germany
Wir besitzen keine Versand- und Lagerfläche in Deutschland und sind nicht von der Rücknahmepflicht nach § 17 ElektroG betroffen.