If I were using Geo Tab to create a bus stop report for individual buses, would the report trigger a "bus stop" for every vehicle in the fleet passing through the created zone or just those that make an actual bus stop indicated by the red light trigger?
Você precisa estar conectado para responder a esta publicação e participar das discussões da Comunidade Geotab.
You can setup the rule to trigger for group of vehicles on your fleet and also if they are stopped in that zone or even add a stopped time also.. The rules are very flexible and choose what is best for your reporting scenario.
so I would like to see if I can create a monthly report for a fleet of buses that would provide the bus stops made and times and then also time of arrival at schools and yards.
the caveat is that many of the buses pass through another buses bus stop without it being on their roster. I don't want that to trigger unnecessarily but also some of the buses share the same bus stop but for different schools so I am guessing that I would need to just pull a red light report showing when they activated their red lights. however, I need miles traveled between yard - first stop - last stop - school and vice/versa for the return. I thought a planned route report would be a better option but am still researching.
@CElvi-3712 Do you have the red lights wired via an IOX-AUXM harness? If so, you'll want a rule something like this: Stopped inside School Zone & Duration > ~15 seconds & AUX = ON.
@ssartor I am unsure of the hardware used to install and I would assume this through the ECM or BCM cable of the bus. I only have parameters to view and pull reports.