Support Document
0 mins to read
Data Set for Geotab Integrated Solution for Ford Vehicles
Support Document
0 mins to read
Learn which data attributes are available with the Ford Premium and Basic device plans, including ignition status, GPS location, odometer, tire pressure, engine information, and more.
Data Attribute (Name in MyGeotab UI) | Device Plan — Ford Premium5 (Available only in US and CA, GPS, Speed ODO every 5 sec, rest at 30 sec) | Device Plan — Ford Premium (Available in US, CA and Europe, Most data reported every 30 seconds) | Device Plan — Ford Basic (Available in US, CA and Europe, Data reported during ignition on and off events or after 24 hours of inactivity) |
Ignition * | ✔ | ✔ | ✔ 3 |
GPS Coordinates | ✔ | ✔ | ✔ 3 |
Odometer | ✔ | ✔ | ✔ 3 |
Tire pressure - front left | ✔ | ✔ | ✔ 3 |
Tire pressure - front right | ✔ | ✔ | ✔ 3 |
Tire pressure - rear left | ✔ | ✔ | ✔ 3 |
Tire pressure - rear right | ✔ | ✔ | ✔ 3 |
ALERT: Accident limit for acceleration exceeded * | ✔ 2 | ✔ 2 | ✔ 2 |
Corresponding Fault Code / DTC | ✔ 2 | ✔ 2 | ✔ 2 |
Fault: General vehicle warning light is on | ✔ 2 | ✔ 2 | ✔ 2 |
Generic ABS active | ✔ | ✔ | ✘ |
Acceleration forward or braking * | ✔ | ✔ | ✘ |
Acceleration side to side * | ✔ | ✔ | ✘ |
Accelerator pedal position | ✔ | ✔ | ✘ |
Telematics device voltage | ✔ | ✔ | ✘ |
Brake pedal on | ✔ | ✔ | ✘ |
Engine coolant temperature | ✔ | ✔ | ✘ |
Engine speed | ✔ | ✔ | ✘ |
Engine oil temperature * | ✔ | ✔ | ✘ |
Fuel level (percentage) | ✔ | ✔ | ✘ |
Total fuel used (since telematics device install) | ✔ | ✔ | ✘ |
Total fuel used while idling (since telematics device install) | ✔ | ✔ | ✘ |
Gear position * | ✔ | ✔ | ✘ |
Engine road speed | ✔ | ✔ | ✘ |
Engine oil life remaining | ✔ | ✔ | ✘ |
Passenger occupancy | ✔ | ✔ | ✘ |
Passenger seatbelt violation * | ✔ | ✔ | ✘ |
Driver seat belt * | ✔ | ✔ | ✘ |
Engine operational time * | ✔ | ✔ | ✘ |
Total engine idle time * | ✔ | ✔ | ✘ |
Traction control system enabled * | ✔ | ✔ | ✘ |
Generic state of charge [%] | ✔ 1 | ✔ 1 | ✘ |
Electric vehicle charging state (0 = not charging / 1 = AC charging / 2 = DC charging) | ✔ 2 | ✔ 2 | ✘ |
Electric vehicle battery total energy out while driving (since telematics device install) [kWh] | ✔ 2, 5 | ✔ 2, 5 | ✘ |
Electric vehicle battery total energy in during AC charging (since telematics device install) [kWh] | ✔ 2, 5 | ✔ 2, 5 | ✘ |
Electric vehicle battery total energy in during DC charging (since telematics device install) [kWh] | ✔ 2, 5 | ✔ 2, 5 | ✘ |
Electric vehicle battery charge remaining | ✔ 2 | ✔ 2 | ✘ |
Electric vehicle distance remaining [Km] | ✔ 4 | ✔ 4 | ✘ |
Charge plug connected (electric vehicle message) | ✔ 2 | ✔ 2 | ✘ |
High HV battery cell temperature | ✔ 2 | ✔ 2 | ✘ |
Generic DEF range | ✔ 2 | ✔ 2 | ✘ |
DEF level | ✔ 2 | ✔ 2 | ✘ |
Diesel particulate filter 1 soot load percent | ✔ | ✔ | ✘ |
Generic DPF filter regen force switch (1 = on) | ✔ | ✔ | ✘ |
Diesel exhaust fluid status level (0 = normal / 1 = low level warning / 2 = empty level warning / -1 = unknown) | ✔ | ✔ | ✘ |
Diesel Particulate Filter (DPF) status (0 = normal / 1 = overloaded / 2 = at limit / 3 = over limit / -1 = unknown) | ✔ | ✔ | ✘ |
Diesel exhaust fluid quality (1 = contaminated) | ✔ | ✔ | ✘ |
Automatically clean diesel exhaust filter (0 = allowed / 1 = not allowed / -1 = unknown) | ✔ | ✔ | ✘ |
Maximum vehicle road speed limit due to Diesel Exhaust Fluid (DEF) levels | ✔ | ✔ | ✘ |
Water in fuel warning light on | ✔ 2 | ✔ 2 | ✘ |
Limp mode active | ✔ 2 | ✔ 2 | ✘ |
Collision mitigation brake status | ✔ 6 | ✔ 6 | ✘ |
Driver assistance system enabled | ✔ 6 | ✔ 6 | ✘ |
ESC or ESP system enabled (ESC: Electronic Stability Control; ESP: Electronic Stability program) | ✔ 6 | ✔ 6 | ✘ |
ESC or ESP status | ✔ 6 | ✔ 6 | ✘ |
Low speed collision mitigation status | ✔ 6 | ✔ 6 | ✘ |
Low speed collision mitigation system enabled | ✔ 6 | ✔ 6 | ✘ |
Generic blind spot monitoring system | ✔ 6 | ✔ 6 | ✘ |
Uncategorized driver distraction detected | ✔ 6 | ✔ 6 | ✘ |
ADAS forward collision warning | ✔ 6 | ✔ 6 | ✘ |
Forward collision detection system enabled | ✔ 6 | ✔ 6 | ✘ |
Generic lane departure detection enabled | ✔ 6 | ✔ 6 | ✘ |
Generic rear cross traffic system | ✔ 6 | ✔ 6 | ✘ |
* Data reporting varies. Refer to the Data Description section for more information.
1 Reported every 30 seconds.
2 Reported based on events.
3 Reported at ignition on or off events only.
4 Reported when charging status changes; every 15 mins for AC charging; every 5 mins for DC charging.
5 Reported only for BEVs. Energy signals and related reports are not available for PHEVs.
6 ADAS signals: If the vehicle is not capable, these signals are reported as inactive / disabled
✱ NOTE: Electric Vehicle (EV) signals are available only on 2020 or newer models. Focus Electric is not supported.
Data Descriptions
Accident Event
An accident event is reported based on the following conditions:
- The reported acceleration exceeds 2.6G.
- Ford detects an accident via the vehicle sensors. In this case, the event is reported as Fault 166. This could be included as a trigger condition in the ‘Possible Collision’ rule to improve accuracy.
- Forward acceleration (Hard Acceleration) — Reported every 30 seconds and also when acceleration remains above 0.41G (4 m/s^2) for 2 seconds
- Backward acceleration (Harsh Braking) — Reported every 30 seconds and also when acceleration remains below -0.31G (3 m/s^2) for 2 seconds
- Side to side acceleration (Harsh Cornering) — Reported every 30 seconds and also accompanied when harsh braking or acceleration event occurs
Acceleration
An acceleration event is reported based on the following conditions:
ABS Active Status
The Anti-lock Brake System (ABS) active status is indicated as:
- 0 — The ABS system is inactive.
- 1 — The ABS system is active.
- 0 — The Brake Pedal system is inactive.
- 1 — The Brake Pedal system is active.
- Negative numbers — The gear position is in reverse.
- Positive numbers — The gear position is in forward.
- 0 — The gear position in neutral.
- 126 — The gear position in park.
- 127 — The gear position in drive
- Reported on gear changes — Based on events.
- 0 — The ignition is off.
- 1 — The ignition is on.
- Reported only when the ignition state changes — Based on events.
- 0 — The passenger seat is unoccupied.
- 1 — The passenger seat is occupied.
- 0 — The seatbelt is buckled.
- 1 — The seatbelt is unbuckled.
- 0 — The traction control is off.
- 1 — The traction control is on.
Brake Pedal Status
The Brake Pedal status is indicated as:
Gear Position
The gear position is indicated as:
✱ NOTE: This data point is available only on vehicles with automatic transmission.
Engine Oil Temperature
This data point is available only on select vehicles fitted with an engine oil temperature sensor.
Ignition Status
The ignition status is indicated as:
Passenger Occupancy Status
The passenger occupancy status is indicated as:
Road Speed
The road speed is reported every 30 seconds, and when the vehicle speed is greater than 137 km/h for 10 seconds or more.
Seatbelt Status
The seatbelt status is reported every 30 seconds, and when the seatbelt is unbuckled when the vehicle has been moving at five km/h for three seconds. The seatbelt is indicated as:
Traction Control Status
The traction control status is indicated as:
Total Fuel Used
The total fuel used is reported at the end of a trip, and calculated from the day the device was activated.
Total Engine Time / Total Engine Idle Time / Traction Control Status
The total engine and total engine idle time, and traction control status are reported during ignition on and off events for the following truck and commercial vehicle models:
- F-150, F-250, F-350, F-450
- F-550, F-650, F-750
- Explorer U625 S2 Police
- Fusion CD391N M2 Police
- Continental D544 M3.1 Livery
For more detailed information, refer to the Rate Plan Features - Geotab Integrated Solution for Ford Vehicles.
