I am currently trying to configure my spreader integration. After installing my IOX-works cable, I have set my spreader controller type within the public works menu . I am, however having an issue figuring out how to display treatment progress on the map in the same way that I would track exceptions when using the IOX-AUX cable. While I can verify measurements within the public Works menu, I do not see any options to track the status of whether or not the spreader is on or off.
You need to be logged in to reply to this post and participate in the Geotab Community discussions.
Hello @DGord-1989 ,
Thank you for asking your question in our community. It may depend on exactly what you are looking to see. Usually customers get their IOX-WKRS devices install in their plows and then upload their routes into the Route Completion section/feature of MyGeotab. This will then show progress of which sections have been completed and so on. If you haven't done the route upload (i.e. using a shapefile) then that might be the next step.
Route Completion Configuration with a Shapefile [PUBLIC]
Route Completion Excel/CSV Import [PUB]
Let me know if you have any other questions or any additional information and I will see how we can best support you.
Have a good one!
Eishi FUN
Hello @DGord-1989 ,
Thank you for asking your question in our community. It may depend on exactly what you are looking to see. Usually customers get their IOX-WKRS devices install in their plows and then upload their routes into the Route Completion section/feature of MyGeotab. This will then show progress of which sections have been completed and so on. If you haven't done the route upload (i.e. using a shapefile) then that might be the next step.
Route Completion Configuration with a Shapefile [PUBLIC]
Route Completion Excel/CSV Import [PUB]
Let me know if you have any other questions or any additional information and I will see how we can best support you.
Have a good one!
Eishi FUN