Support Document
0 mins to read
Geotab Integrated Solution for Freightliner
Name in MyGeotab UI | Device Plan: Freightliner Premium | Data Frequency or Trigger Condition |
Ignition | ✔ | 1 second |
GPS Coordinates | ✔ | 1 second |
Engine road speed | ✔ | 1 second |
Odometer | ✔ | 30 seconds |
Engine speed | ✔ | 1 second |
Engine operational time | ✔ | 3 - 6 mins |
Telematics device voltage | ✔ | 30 seconds |
Driver seatbelt (1. Unbuckled) 1 | ✔ 1 | Event-based |
Acceleration forward or braking | ✔ | 1 second |
Engine warning light (1. On) | ✔ | Event-based |
Tire pressure: Front left 1 | ✔ 1 | 30 seconds |
Tire pressure: Front right 1 | ✔ 1 | 30 seconds |
Tire pressure: Rear right/Outer rear right 1 | ✔ 1 | 30 seconds |
Tire pressure: Rear left/Outer rear left 1 | ✔ 1 | 30 seconds |
Tire pressure: axle # tire # 1 | ✔ 1 | 30 seconds |
Tire temperature: axle # tire # 1 | ✔ 1 | 30 seconds |
Gear position (negative #s = reverse gears / positive #s = forward gears / 0 = neutral / 126 = park / 127 = drive / 129 = intermediate) | ✔ | Event-based |
Total fuel used (since telematics device install) | ✔ 6 | 30 seconds |
Fuel level (percentage) | ✔ | 30 seconds |
Engine coolant temperature | ✔ | 30-60 seconds |
Acceleration side to side | ✔ | 1 second |
Total engine idle time | ✔ 2 | Event-based 3 |
Total fuel used while idling (since telematics device install) | ✔ 2 | Event-based 3 |
Altitude above mean sea level | ✔ | 1 second |
Outside air temperature | ✔ | 30-60 seconds |
Engine PTO governor enable switch 1 | ✔ | Event-based |
PTO governor state 1 | ✔ | Event-based |
Device power change (1. Powered) | ✔ | Event-based |
Engine data (0. Inactive, 1. Active) | ✔ | Event-based |
Log data buffer overrun | ✔ | Event-based |
Parking brake (1. On) | ✔ | Event-based |
DEF level | ✔ | 30 seconds |
Corresponding Fault Code/DTC | ✔ | Event-based |
Generic ABS active 4 | ✔ 4 | Event-based |
Cruise control active 4 | ✔ 4 | Event-based |
Collision mitigation brake status 4 | ✔ 4 | Event-based |
Adaptive cruise control set distance mode 4 | ✔ 4 | Event-based |
Adaptive cruise control distance alert signal (0. Not active, 1. Active, 2. Reserved, 3. Not available) 4 | ✔ 4 | Event-based |
Generic distance to forward vehicle 4 | ✔ 4 | Event-based |
ADAS left lane departure warning 4 | ✔ 4 | Event-based |
ADAS right lane departure warning 4 | ✔ 4 | Event-based |
Blind spot event detected (1. Detected) 5 | ✔ 5 | Event-based |
1 Only available on vehicles with the respective sensor
2 Under investigation
3 Only reported when a vehicle ECU requests the signal
4 Only reported when the vehicle has Detroit Assurance package active
5 Only reported when the vehicle has Detroit Assurance and Side guard assist packages active
6 Under investigation for P4 Cascadia (MY2022+) with Cummins
Data description
Gear position (negative #s = reverse gears / positive #s = forward gears / 0 = neutral / 126 = park / 127 = drive / 129 = intermediate)
This data point is available only on vehicles with automatic transmission.
- Negative numbers = Reverse gears
- Positive Numbers = Forward gears
- 0 = Neutral
- 126 = Park
- 127 = Drive
- Reported on every gear change
Ignition status
- 0 = Off
- 1 = On
- Reported every second
