Install Insert
0 mins to read
•Geotab IOX-WRKS Installer LED Tool Guide
Install Insert
0 mins to read
•This document provides information about the Geotab IOX-WRKS installation process with an optional add-on LED tool. As an installer, it is your responsibility to complete the actions outlined in the official IOX-WRKS Installation Guide before installing the USB-powered LED lamp into the IOX-WRKS harness.
This document provides information about the Geotab IOX-WRKS installation process with an optional add-on LED tool.
As an installer, it is your responsibility to complete the actions outlined in the official IOX-WRKS Installation Guide before installing the USB-powered LED lamp into the IOX-WRKS harness.
Stages of the USB LED Lamp:
Beta Version (April 8, 2021) | Version 22 (current) | Meaning | ||
---|---|---|---|---|
Stage | LED Pattern | Stage | LED Pattern | |
0 | OFF | 0 | OFF | No power to Chione |
1 | 1 blink | 1 | 1 blink | Power to Chione |
2 | 2 blinks | 2 | 2 blinks | System is Healthy, but not configured yet |
3 | Solid light (serial only) | 3 | 3 blinks (serial and CAN lights) | Set Spreader Worked (configuration is not the default) |
N/A | N/A | 4 | Inverted 1 blink | Received Data from Spreader Controller |
N/A | N/A | 5 | Flickering | Received Ack from MyGeotab (data shown on screen) |
4 | OFF | N/A | N/A | The USB LED program is no longer running. |
Geotab Public Works Support Contact Information | |
---|---|
Phone Number | 1-800-984-6175 |
Hours of Operation | Monday to Friday — 7:30 a.m. to 8:00 p.m. EST Saturday — 11:00 a.m. to 7:00 p.m. EST |
Geotab Public Works Support will assist the Installer with the following when on-site:
Any 5V single-light USB LED device is supported. The program controlling the LED is generic and only controls the voltage supplied to the USB port.