Liigu edasi põhisisu juurde

Go device Rate Plan Suspend Mode

drewfields
Originaal plakat

My plan was suspended by my reseller by mistake and then updated again. However my devices still say suspended even though reseller shows them active. Is there a time delay on them activating again? My reseller says everything is active on their side, geotab says give it 24 hrs on their side. What do I do?

Liituge vestlusega

You need to be logged in to reply to this post and participate in the Geotab Community discussions.

Parimad vastused

I've noticed that the label on the Asset page seems to have a bug and still shows up, even when the device has been reactivated. As far as I can tell, the device works fine, it just has the label that it's suspended.

3 Vastused

EishiFUN
Kogukonna administraator

Hey @drewfields ,

Thank you for asking your question in our community. When the device heartbeats this should connect it to our servers to get the update. Will you try to start the ignition and run the vehicle for a minute and see if it gets the update?

It shouldn't necessarily need this but I believe it will help it get the update. Let me know how this goes and if there is more investigation needed we can do that.

Have a good one!
Eishi FUN

I've noticed that the label on the Asset page seems to have a bug and still shows up, even when the device has been reactivated. As far as I can tell, the device works fine, it just has the label that it's suspended.

It's normal for there to be a delay. When a device is reactivated in MyAdmin, it can take up to 24 hours to fully sync with MyGeotab and resume transmitting data. If after 24 hours the devices still appear as suspended in MyGeotab, I recommend asking your dealer to check the status in MyAdmin again.

Kas teil on ikka küsimusi?